Description
SMOK RPM 2 Coils: 0.16 Mesh, 0.25 DC and 0.6 DC MTL SMOK RPM 2 coils are the second-generation RPM coil, five to a pack, and SMOK makes them in three resistances: the RPM 2 Mesh 0.16Ω, the RPM 2 DC 0.25Ω and the RPM 2 DC 0.6Ω MTL. They go into the RPM 2 pod of SMOK’s larger pod mods – the Nord 4, Nord X, IPX80, Thallo, G-Priv pod kit and the RPM 2 itself. RPM 2 is not simply a newer RPM: the two families use different pods. An RPM 2 coil won’t go into an RPM40 or Fetch Pro, and an RPM coil won’t go into an RPM 2 pod. SMOK’s own coil card for the RPM 2 Mesh 0.16Ω and RPM 2 DC 0.6Ω MTL. 🔌 SMOK RPM 2 Coils ✔ Five coils per pack ✔ RPM 2 Mesh 0.16Ω for direct lung ✔ RPM 2 DC 0.6Ω for MTL ✔ RPM 2 DC 0.25Ω ✔ For RPM 2 pods only ✔ Not for the RPM40 or Fetch Pro RPM 2 Coil Wattage by Resistance Wattages from SMOK’s IPX80 and Nord 4 coil cards. SMOK lists the 0.25Ω DC but prints no wattage for it, so we don’t guess. Coil SMOK wattage Draw RPM 2 Mesh 0.16Ω 25–50W, best 40W Direct lung RPM 2 DC 0.25Ω Not published by SMOK Sub-ohm, dual coil RPM 2 DC 0.6Ω MTL 12–25W MTL, dual coil White Vape Co recommends: for clouds and flavour on a Nord 4 or IPX80, the Mesh 0.16Ω at around 40W with a 70% VG freebase. For nic salts, the DC 0.6Ω MTL is the only RPM 2 coil we’d use – keep it under 25W. Our listing also shows 0.3Ω, 0.4Ω, 1.0Ω and 1.2Ω options: those are resistances from the original RPM range, so if your device takes RPM coils, see our SMOK RPM coils instead. What Does the RPM 2 Coil Fit? SMOK’s compatibility table lists RPM 2 coils for the RPM 2 pod of eight kits: the G-Priv pod kit and G-Priv Pro, IPX80, Nord 4, Thallo and Thallo S, Nord X, RPM 2 and RPM 2S, SCAR-P3 and SCAR-P5. We don’t sell an RPM 2-pod device. For RPM40, Fetch Pro or Nord 2 owners, the right coil is in our SMOK RPM coils , and the SMOK Fetch Pro RPM pod takes those, not RPM 2. Will not fit: the RPM40, Fetch Pro, Nord 2, RPM 4, RPM80, Alike, Pozz X or Fetch Mini – all of those take original RPM coils. The RPM 5 uses SMOK RPM 3 coils . How to Fit and Prime an RPM 2 Coil Pull the RPM 2 pod out of the device and ease the old coil out of the bottom. Wet the cotton through each wicking hole with two or three drops of e-liquid. Press the new coil in until the rubber seal sits flush with the pod base. Open the rubber plug, fill slowly, close it firmly and give it a few minutes to soak. Start the Mesh 0.16Ω at about 25W or the DC 0.6Ω at about 12W, then work up. How Long Does an RPM 2 Coil Last? SMOK gives no figure. The DC 0.6Ω MTL on nic salts outlasts the Mesh 0.16Ω at 40W because it does less work. Replace either at the first dry or bitter hit. RPM 2 Coil Troubleshooting Problem Likely cause and fix Coil won’t go into the pod It is almost always the wrong family. RPM 2 pods take RPM 2 coils; RPM pods take RPM coils. SMOK marks each pod. Spitting on the 0.16Ω Wattage too low for mesh, or e-liquid too thin. Try 35–40W and a higher-VG liquid. Harsh on nic salts Salts are not a good match for the 0.16Ω or 0.25Ω. Use the 0.6Ω MTL. RPM vs RPM 2 vs RPM 3 Coils RPM RPM 2 RPM 3 Resistances 0.3–1.2Ω plus RBA 0.16, 0.25, 0.6Ω 0.15, 0.23Ω Example kits RPM40, Fetch Pro, Nord 2 Nord 4, IPX80, Nord X RPM 5, RPM 5 Pro Swap between families? No No No Some SMOK kits ship with both an RPM and an RPM 2 pod: check the pod, not just the device. Best E-Liquids for RPM 2 Coils On the Mesh 0.16Ω and DC 0.25Ω, use a high-VG freebase at 3mg or 6mg: a shortfill e-liquid topped up with a nicotine shot is the usual choice. On the DC 0.6Ω MTL, nic salts at 10mg or 20mg, or a 50/50 10ml e-liquid . Buy RPM 2 Coils Near You Need RPM 2 coils today? Our Totton vape shop , Hythe vape shop and Holbury vape shop stock replacement pods, coils and kits, and the team can check which resistance suits your device and e-liquid. Bring the pod with you: we’ll tell you in seconds whether it takes RPM or RPM 2. Stock varies by store, so give us a call before you travel. Ordering online instead? See our delivery options . You May Also Like SMOK RPM Coils SMOK RPM 3 Coils All Replacement Coils Shortfill E-Liquids All SMOK Products Frequently Asked Questions Are RPM and RPM 2 coils the same? No. They are different sizes for different pods and do not swap. SMOK lists them as separate series. Do RPM 2 coils fit the SMOK Nord 4? Yes, in the Nord 4 RPM 2 pod. The Nord 4’s other pod takes original RPM coils. Which RPM 2 coil is best for nic salts? The RPM 2 DC 0.6Ω MTL, at 12–25W. Do RPM 2 coils fit the RPM40? No. The RPM40’s pods take RPM and Nord coils.
